scbenoit

Members
  • Content count

    5
  • Joined

  • Last visited

Community Reputation

0 Neutral

About scbenoit

  • Rank
    Newbie
  1. Isn't that always the way ? I looked at this for quite some time before posting, and as soon as I posted I found this statement on Geniatech site stating that my version o f950 isn't supported. https://www.geniatech.eu/eyetv/faq/eyetv-3-software-does-not-support-current-wintv-hvr-950q/ BTW, EyeTV starts and stops fine without the 950 connected. Thanks for looking at the post.
  2. EyeTV 3 error with haulage HVR-950Q

    Isn't that always the way ? I looked at this for quite some time before posting, and as soon as I posted I found this statement on Geniatech site stating that my version o f950 isn't supported. https://www.geniatech.eu/eyetv/faq/eyetv-3-software-does-not-support-current-wintv-hvr-950q/ BTW, EyeTV starts and stops fine without the 950 connected. Thanks for looking at the post.
  3. Good day folks I can't get EyeTV to work, I can't tune in any channels. My EyeTV starts fine when I connect the HVR-950Q , or by double clicking on it. In EyeTV Preferences, EyeTV properly recognizes my Haulage HVR-950Q. However I can not get it ti auto-tune any channels, or to manually accept any channels. It shows 0 signal strength. On my Linux system, the HVR-950Q/antenna setup works fine and I get 3 channels. So I know the stick is good, and the antenna placement is good 'cause I get 3 channels, it just won't work under EyeTV on MacOS Finally, EyeTV locks up when I select File and Quit, never exiting. I have to Force Quit EyeTV Any suggestions ? I tried EyeTV reporter and uninstalled and re-installed EyeTV - Are there any advanced diagnostics or debug routines beyond "EyeTV Reporter"? thanks Steve
  4. Unable to tune in any channels

    Richard - can you point me to the 7416 version download - I seem to only be able to download the latest version I'm having a similar problem however, the channels are showing 0 signal, instead of the 100 % you were seeing. Thanks Steve
  5. I've not been able to run EyeTV for some time now (years) and decided to try it again today. I've upgraded EyeTv to 7520 and am on El Capitan 10.11.6 EyeTV starts fine when I connect the HVR-950Q , or by double clicking on it. In EyeTV Preferences, EyeTV properly recognizes my Haulage HVR-950Q. However I can not get it ti auto-tune any channels, or to manually accept any channels. It shows 0 signal strength. On my Linux system, the HVR-950Q/antenna setup works fine and I get 3 channels. So I know the stick is good, and the antenna placement is good 'cause I get 3 channels, it just won't work under EyeTV on MacOS Then EyeTV locks up when I select File and Quit, never exiting. I have to Force Quit EyeTV Any suggestions ? I tried EyeTV reporter and uninstalled and re-installed EyeTV thanks Steve