fissionbomb 5 Report post Posted November 24, 2016 Hi guys, I have a problem with my EyeTV Netstream 4Sat. even two friends of mine have the same problem. from time to time EyeTV Netstream 4Sat just stops to respond and im geting "In use by another client" message. but i am the only person using the device in my apartment. i can ping it, ethernet connection is active but if i enter devices ip nothing happens (normally there is a landing page for EyeTV Netstream 4Sat). green/power led is lid. the blue led stops to blink.. i believe that there something with the firmware (today i have 1.1.0.402r1-V1).. Are you guys working for a newer firmware? and yes i already factory restored it. Quote Share this post Link to post Share on other sites
Mikyesun 26 Report post Posted February 2, 2017 Thank for your question, are this happen after you used it with: a) eyetv 3 on Mac b) netstream APP iOS c) netstream, APK for Android ? Quote Share this post Link to post Share on other sites
fissionbomb 5 Report post Posted February 14, 2017 it is happening with eye 3 on a mac. Quote Share this post Link to post Share on other sites
boyfarrell 0 Report post Posted August 3, 2017 Same problems here. Steps: 1) Initialised, tunes and watched TV on iPhone 2) Downloaded, installed EyeTV3 3.6.9 (7520), tuned on the macOS 10.12.3. Tuning could not find any channels; through the whole tuning process the "In use by another client" was displayed in the TV window. I then, preformed the tuning again, the second time it worked... Needs more reliability in setup... Quote Share this post Link to post Share on other sites
Igl 1 Report post Posted January 4, 2018 (edited) I used the software code from my former eyeTV DTT-Stick with NetStream 4Sat - and had the same problems (and some more). I performed the tuning quite a hundred times (like @boyfarrell recommended above) - and still had this problem. Thank to @Georgio8 (*) I solved most (and this) kind of trouble with my NetStream 4Sat: deinstalling eyeTV 3 on all my Macs with the Reporter Tool reinstall eyeTV 3 using the software code that came with the NetStream 4Sat Perhaps this will help someone *) Edited January 4, 2018 by Igl Quote Share this post Link to post Share on other sites