ThoSchl 5 Report post Posted May 28, 2017 (edited) Hello, I'd like to know if there is a possibility to read signal quality by command line. I have the problem that my SAT-antenna seams to overheat. I use EyeTV 3 with a sat receiver attached by USB. So, I'd like to record signal quality every 5 minutes and see at which outside temperature it stops working. Any ideas? Thanks in advance ThoSchl Edited May 28, 2017 by ThoSchl 1 Quote Share this post Link to post Share on other sites
Mikyesun 26 Report post Posted June 2, 2017 On 28.5.2017 at 4:17 PM, ThoSchl said: Hello, I'd like to know if there is a possibility to read signal quality by command line. I have the problem that my SAT-antenna seams to overheat. I use EyeTV 3 with a sat receiver attached by USB. So, I'd like to record signal quality every 5 minutes and see at which outside temperature it stops working. Any ideas? Thanks in advance ThoSchl Hi - need to check - how that can be performed ... - the debug version of eyetv 3 does support similar feature, anyway we need to check // Mike 1 Quote Share this post Link to post Share on other sites