scbenoit 0 Report post Posted August 5, 2017 Good day folks I can't get EyeTV to work, I can't tune in any channels. My EyeTV starts fine when I connect the HVR-950Q , or by double clicking on it. In EyeTV Preferences, EyeTV properly recognizes my Haulage HVR-950Q. However I can not get it ti auto-tune any channels, or to manually accept any channels. It shows 0 signal strength. On my Linux system, the HVR-950Q/antenna setup works fine and I get 3 channels. So I know the stick is good, and the antenna placement is good 'cause I get 3 channels, it just won't work under EyeTV on MacOS Finally, EyeTV locks up when I select File and Quit, never exiting. I have to Force Quit EyeTV Any suggestions ? I tried EyeTV reporter and uninstalled and re-installed EyeTV - Are there any advanced diagnostics or debug routines beyond "EyeTV Reporter"? thanks Steve Quote Share this post Link to post Share on other sites
scbenoit 0 Report post Posted August 5, 2017 Isn't that always the way ? I looked at this for quite some time before posting, and as soon as I posted I found this statement on Geniatech site stating that my version o f950 isn't supported. https://www.geniatech.eu/eyetv/faq/eyetv-3-software-does-not-support-current-wintv-hvr-950q/ BTW, EyeTV starts and stops fine without the 950 connected. Thanks for looking at the post. Quote Share this post Link to post Share on other sites