Fish 0 Report post Posted August 12, 2016 Hi I find the Netstream 4C a very interesting alternative to the HDHomerun products, especially with implemented hardware transcoding. However I seek more information on the transcoding capabilities and how to access and configure the streams from the Netstream Is interfacing to the Netstream 4C done by standardized SAT > IP protocol and/or is something propritary put on top? Which formats can the Netstream transcode to? Different bitrates? If several formats/bitrates can be supplied. When requesting a stream, (how) can I request a certain format/bitrates Seeking all documentation regarding this. Br Fish Quote Share this post Link to post Share on other sites
Ton 29 Report post Posted August 13, 2016 Beware. I've had one for almost 30 days. Never was able to use more than 2 out of 4 decoders. Mail with Geniatech did not bring any solution. Also, it will not work with widespread software like DVBlink and TVHeadend. So it's a waste of money. Quote Share this post Link to post Share on other sites
Hannes 0 Report post Posted January 31, 2017 On 13.8.2016 at 8:30 AM, Ton said: Beware. I've had one for almost 30 days. Never was able to use more than 2 out of 4 decoders. Mail with Geniatech did not bring any solution. Also, it will not work with widespread software like DVBlink and TVHeadend. So it's a waste of money. Yes, I agree. There is no "Support" and the Software "runs" as a pig with one leg. They are not able to even respond on basically install-problems as msvcr90.dll in setup of "Home Cinema"..... Quote Share this post Link to post Share on other sites